Kickstand Installation Guide

The KG4 comes with a sturdy double kickstand. If it needs to be replaced, follow these instructions.

Tools needed:

• 15mm wrench
• 8mm Allen wrench
• M10 nut with washer
• Kickstand provide from Keego
• Bolt (M10*75L)

1. Put the ebike against a wall to balance the bike while you work on the kickstand
2. Position the kickstand under the chainstays. Just behind the bottom bracket, there is a weld plate where you will install the kickstand
3. Insert the bolt into the hole. The bolt should pass the weld plate hole and line up with the threaded hole in the top of the kickstand.
4. Install the nut, there is a groove in the base of kickstand. Tighten the nut. The nut should pass through the bolt to the groove
5. Use a 15mm wrench to hold the nut and a 8mm Allen wrench to torque to 45 Nm
6. Complete